How one can allow system in cgminer?


CGMiner does not include help for that individual miner by default. I consider you need to get the driving force for it. You should utilize bfgminer, which from 5.3.0 helps your miner out of the field.

Directions from

The stickminer will enumerate as an antminer U3 on cgminer (if the model of cgminer you are utilizing helps the U3), and will run high quality. It might give warnings about “no legitimate hashes inside 3 seconds” however that is high quality, because the U3 has a better hashrate, complicated cgminer however not noticeably affecting efficiency. In case your {hardware} errors are low you are high quality. These older model of cgminer don’t permit a clock charge over 250MHz. That is fairly good for most individuals as that is reasonably excessive energy however in idea the chips will run as much as 500MHz.

Luke Jr added bfgminer help in bfgminer 5.3.0, so you could use that
model of bfgminer.

I (novak) have written a cgminer driver which enumerates the compacs
as anticipated, removes the error, and ramps up the clock slowly to
stop spikes on USB energy. My customized cgminer might be discovered right here:
supply code: win32 binary: EDIT: The present
model helps bitshopper compacs as effectively, and might be (and is, in
the case of home windows) compiled with icarus help.

I’ve not but examined it however edonkey was good sufficient to add a
customized minera picture with cgminer-gekko enabled as a customized miner. You
can set the frequency beneath guide choices as: –compac-freq 150.

On the engineering pattern sticks you may solely use previous cgminer because the
newer drivers for each cgminer and bfgminer rely upon a hexfile
flashed to the cp2102 which the engineering samples don’t have.

If it’s worthwhile to run cgminer on home windows (both inventory or mine), you will
want to put in the zadig driver. You will discover it right here:

Run this system and set up the winusb driver for the compac(s) that
you might have plugged into your home windows machine. You might have to replug
the compacs afterwards whereas cgminer is operating to get them to start out


Outdated cgminer: To construct use –enable-icarus flag.

./cgminer -o stratum+tcp:// -u

1BURGERAXHH6Yi6LRybRJK7ybEm5m5HwTr –au3-freq 150

GekkoScience cgminer: To construct use –enable-gekko flag.

./cgminer -o stratum+tcp:// -u

1BURGERAXHH6Yi6LRybRJK7ybEm5m5HwTr –compac-freq 150


./bfgminer -o stratum+tcp:// -O

1BURGERAXHH6Yi6LRybRJK7ybEm5m5HwTr –set compac:clock=x0b83

Supply hyperlink

Leave a reply